搜索
Search

Products

From products to services, Casstar is beside you

/
/
/
9530-D Neutral Silicone Adhesive Sealant
Number of views:
1013

9530-D Neutral Silicone Adhesive Sealant

Retail price
0.0
Market price
0.0
Number of views:
1013
Product serial number
Quantity
-
+
Stock:
1
Description

I. Product Features:

1. KSD-9530-D one-component silicone adhesive sealant is cured at room temperature, non-toxic and pollution-free;

2. It’s featured by fast curing speed, low volatilization, and no release of irritant gas;

3. It has excellent electrical insulation and arc resistance, good damp and heat resistance, and can be used for a long time in the temperature range of-60 to 200 ℃;

3. It has excellent electrical insulation and arc resistance, good damp and heat resistance, and can be used for a long time in the temperature range of-60 to 200 ℃;

5. It has excellent heat resistance, cold resistance, moisture resistance and other anti-aging properties, and good airtight performance.

6. It is soft rubber after curing and has good impact resistance.

 

II. Typical Applications:

1. Bonding and sealing of motor shaft hole and motor wire harness hole and other parts of the motor;

2. Bonding and sealing of all kinds of cars, motorcycles, mechanical equipment, chemical equipment, and electronic components;

3. Bonding and sealing in other industrial fields.

 

III. Executive Standard:Q/KSD 013-2018

 

IV. How to Use:

1. Substrate surface: clean the glue surface to remove stress, dust, oil stain, rust, etc.

2. Apply glue: Open the rubber bottle cap, squeeze the glue solution onto the cleaned and cure it from the surface to the inside. The unused glue shall be capped immediately, and sealed and stored.If there is a little crust on the sealing part, it can be removed for use;

3. Test before use to determine curing and bonding conditions;

4. Curing: Place the glued or sealed parts in air to allow them to cure naturally. The curing is from the surface to the inside. If the position is deep, especially in the position that is not easy to contact with air, the time for complete curing will be prolonged. If the temperature is lower, the curing time will also be prolonged. Usually it needs to be left for 24 hours to cure.

 

V.matters needing attention:

1. After the operation is completed, the unused glue shall be capped immediately, and sealed and stored.

2. When it is used again, if there is a little crust on the sealing part, it can be removed without affecting the normal use.

3. During the storage process, a small amount of curing may occur at the nozzle, which can be used normally without affecting the performance after being removed.

 

VI.Packaging Specifications:

KSD-9530-D, 310ml/piece, 2600 ml/piece; or packaged according to customer's requirements

 

Ⅶ Storage and Transportation

1. Be stored in a cool and dry place for 9 months (below 28℃);

2. This product is non-hazardous and can be transported as general chemicals.

3. The product shall be sealed and stored to avoid extrusion and collision during transportation.

4. Products exceeding the storage period shall be inspected and confirmed to be free from abnormality before use.

Scan the QR code to read on your phone
We could not find any corresponding parameters, please add them to the properties table

Contact us

TEL:+86 576 84882118

FAX:+86 576 84833969

ADD: No 172 Yuandian Load,Yuanqiao

            Industrial Zone, Huangyan,Taizhou, Zhejiang

科思达

Copyright 2019 ©copyright casstar.cn  浙ICP备19026256号