搜索
Search

Products

From products to services, Casstar is beside you

/
/
/
KSD-9510 Lighting Fixture Silicone Sealant
Number of views:
1010

KSD-9510 Lighting Fixture Silicone Sealant

Retail price
0.0
Market price
0.0
Number of views:
1010
Product serial number
Quantity
-
+
Stock:
1
Description

I. Product Features:

1. KSD-9510 one-component dealcoholized silicone adhesive sealant is cured at room temperature;

2. It’s featured by fast curing speed, low volatilization, no corrosion to materials and no release of irritant gas;

3. It has excellent electrical performance and good heat resistance, and can be used for a long time in the temperature range of-60 to 200 ℃;

4. No other primer is needed, and the adhesive force to most metals, plastics, ceramics and glass is good;

5. It has excellent heat resistance, cold resistance, moisture resistance and other anti-aging properties, and good airtight performance,.

6. It is soft rubber after curing and has good impact resistance.

 

II. Typical Applications:

1. Bonding and sealing of car light fixtures and commonly used light fixtures;

2. Bonding and sealing of LED light fixture shell;

3. Bonding and sealing of other light fixtures.

 

III. Executive Standard:Q/KSD 005-2012

 

IV. How to Use

1. Substrate surface: dry, clean, remove stress, dust, oil, etc.;

2, sizing: open the rubber cap, squeeze the glue to the cleaned surface, make it evenly distributed, the fixed surface will be closed and fixed;

3, do the experiment before use, please confirm the curing and bonding;

4. Curing: Place the glued or sealed parts in the air to allow them to cure naturally. The curing process is a curing process from the surface to the inside. Within 24 hours (room temperature and 55% relative humidity), the glue will cure to a depth of about 2-4 mm, if the part is deep, especially in parts that are not easily accessible to air. The time to complete cure will be extended, and if the temperature is lower, the cure time will also be extended. Before further processing or packaging the bonded components, it is recommended that the user wait for a sufficient amount of time to keep the bond firm and integrity unaffected;

5, good adhesion to most substrates such as: PC; but for some low surface energy materials such as: PP need to be plasma or primer treatment, bonding can have a good effect.

 

V.matters needing attention:

1. After the operation is completed, the unused glue should be tightened immediately and sealed.

2. When using it again, if there is a little crust at the seal, remove it and it will not affect the normal use. During the storage process, a small amount of solidification may occur in the nozzle, which can be used normally without affecting performance.

 

VI.Packaging Specifications

KSD-9510, 310ml / support, 25KG / barrel, 240KG / barrel; or according to customer needs for packaging.

 

.Storage and Transportation

1. Store in a cool dry place with a storage period of 9 months (at 28 ° C);

2. Such products are non-dangerous goods and can be transported as general chemicals;

3, the gel must be sealed and preserved, carefully crushed and collided during transportation!

4. Products that exceed the storage period should be confirmed before use.

Scan the QR code to read on your phone
We could not find any corresponding parameters, please add them to the properties table

Contact us

TEL:+86 576 84882118

FAX:+86 576 84833969

ADD: No 172 Yuandian Load,Yuanqiao

            Industrial Zone, Huangyan,Taizhou, Zhejiang

科思达

Copyright 2019 ©copyright casstar.cn  浙ICP备19026256号