Language
- 简体中文
- English

9530-T Neutral Silicone Adhesive Sealant

Keywords：

Category：

Hotline：

I. Product Features:

1. KSD-9530-T one-component silicone adhesive sealant is cured at room temperature, non-toxic and

2. It’s featured by fast curing speed, low volatilization, and no release of irritant gas;

3. It has excellent electrical insulation and arc resistance, good damp and heat resistance, and can be used for a long time in the temperature range of-60 to 200 ℃;

4. It has excellent heat resistance, cold resistance, moisture resistance and other anti-aging properties, and good airtight performance.

5. It is soft rubber after curing.

II. Typical Applications:

1. Sealing of motor end cover

2. Bonding and sealing of all kinds of cars, motorcycles, mechanical equipment, chemical equipment, and electronic components;

3. Bonding and sealing in other industrial fields.

III. Executive Standard: Q/KSD 013-2018

IV. How to Use：

1. Substrate surface: clean the glue surface to remove stress, dust, oil stain, rust, etc.

2. Apply glue: Open the rubber bottle cap, squeeze the glue solution onto the cleaned and cure it from the surface to the inside. The unused glue shall be capped immediately, and sealed and stored. If there is a little crust on the sealing part, it can be removed for use;

3. Curing: Place the glued or sealed parts in air to allow them to cure naturally. The curing is from the surface to the inside. If the position is deep, especially in the position that is not easy to contact with air, the time for complete curing will be prolonged. The thickness of the adhesive layer should not exceed 6mm. If the temperature is lower, the curing time will also be prolonged. Usually it needs to be left for 24 hours to cure.

V.matters needing attention:

1. After the operation is completed, the unused glue shall be capped immediately, and sealed and stored.

2. When it is used again, if there is a little crust on the sealing part, it can be removed without affecting the normal use. During the storage process, a small amount of curing may occur at the nozzle, which can be used normally without affecting the performance after being removed.

VI.Packaging Specifications：

KSD-9530 T,2600 ml/piece

Ⅶ.Storage and Transportation：

1. Be stored in a cool and dry place for 9 months (below 28℃);

2. This product is non-hazardous and can be transported as general chemicals.

3. The product shall be sealed and stored to avoid extrusion and collision during transportation.

4. Products exceeding the storage period shall be inspected and confirmed to be free from abnormality before use.